open TELEMAC-MASCARET The mathematically superior suite of solvers

Dear all

I am modeling a sand trap with suspended sediment, I have the particle size of the non-cohesive sediments, sediment with a concentration of 8.3 g/Lt. and inflow of 10m3/s, I edited my file sisCli.cli so that the bottom is fixed and the cli.cli including Variable 23, but when I run the Telemac 3D output flows should add 10m3/s, have too high values above 250m3/s.
I have 5 different sizes of non-cohesive sediments, but getting the modeling goes I have in the first 4 sediment size classes 0.00m3 and the fifth class goes over 322000 m3.

Attached the screenshot with the error just described and CAS Telemac and Sisyphe files, and file cli.cli sisyhpe.

I hope you can help me find the error.

Best regards.