open TELEMAC-MASCARET The mathematically superior suite of solvers

I am new to using Telemac. I used the automatic installer and it works fine using one processor. When I tried to run it in the parallel mode, It just created the Out_****.exe and other files and then the simulation abort ( the error message is included in the attachment).

I am using windows 7 and after reading other topics in the forum I registered mpich2 and when I run in Cmd ( mpiexec -validate) it return success. but this did not help

I appreciate any Idea to solve this.

Hello

with these informations we can not identify what is your problem. We need much more informations.
which release are you using?
which config are you using? Send us your .cfg file
try first to put PARALLEL PROCESSORS = 1 and run Telemac and tell us if it works or not.

With my best regards
Riadh ATA

Thank you Mr. Riadh, I tried to reinstall windows 7 and now the Telemac V6P3 automatic installer works without errors. I think the problem was a conflict with another program. Anyway thank you for you help

Mahmoud Shehata