TELEMAC-MASCARET Forum: Mesh transformation and visualizacion in Blue Kenue (1/1)

Welcome, Guest

TOPIC: Mesh transformation and visualizacion in Blue Kenue

Mesh transformation and visualizacion in Blue Kenue 7 years 5 months ago #26675

Joel

Hello

I am starting to use telemac 3D I used before the 2D model.

Then I have couple of questions with regards to the mesh.

1. Do I need to modified the mesh I did in 2D to use it in a 3D model. If so how can I do that. I am using Blue Kenue as my pre-processor software. Or is there one command line in telemac which transform the mesh 2D into a 3D.

2. If there is no need to modified the 2D mesh into a 3D mesh. Then How can I visualize the 3D mesh into Blue kenue.

Thank you and very sorry for my basic queries.

Joel

The administrator has disabled public write access.

Mesh transformation and visualizacion in Blue Kenue 7 years 5 months ago #26676

Phelype OFFLINE Senior Boarder Posts: 140 Thank you received: 64	Hello Joel No, there's no need no modify the mesh. Telemac3D does this job for you. To visualize it in Blue Kenue you click on the button "New 3D View" on the toolbar. It'll open a new visualization window that you can use for 3D variables. Best Regards, Phelype
	The administrator has disabled public write access.

Mesh transformation and visualizacion in Blue Kenue 7 years 5 months ago #26682

Joel	Hello Phelype I have drag the mesh into the 3D view however the mesh does not show all the vertical layer I have added as part of my simulation. Do you have any other advice? Thanks Joel
	The administrator has disabled public write access.

Mesh transformation and visualizacion in Blue Kenue 7 years 5 months ago #26683

c.coulet OFFLINE Moderator Posts: 3722 Thank you received: 1031	Hi The mesh itself is always 2D! You should drag a 3D result to have a view of the 3D mesh ... Regards
	Christophe The administrator has disabled public write access.