open TELEMAC-MASCARET The mathematically superior suite of solvers

Hello friends! I'm working on the coupling telemac3d-tomawac version v7p0. The separate simulations have already been tested and run without problem. I made the coupling according to the manual, the input files are read without problem but when allocating the wind file to the variable, inside the hydrodynamic fortran an error message appears, saying: end of file. What could be happening? since when I test only the hirodinamica simulation there is no such problem. Attached the sortie file.


Thank you for your attention.
Pablo

Hello Pablo

I'm not sure, but I think that this kind of issue has akready been fixed in the last release.
Besides, We will have the new release v7p3 in couple of weeks, so v7p0 is becomping very old, and thus you should update your version.

with my kind regards

Riadh