open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi everyone,

I used the TELEMAC v7p0 and it works fine. When I tried to run it in the TELEMAC v7p0 parallel, It just created the out_t3d_stratification.exe and other files and then the simulation abort ( the error message is included in the attachment).

And the other three files about parallel mode are attached.

Any suggestions are appreciated.

With best regards,
Liwei

Hi
At 99% it is not a fail!
This has been largely discussed on the forum.
When Telemac seems to stop in parallel, this is because mpi wait for the login and password account!
To avoid this problem you have to register your account with wmpiregister and then the problem disappear.

Regards

Hello coulet,

Thanks for your help. I have registered wmpiregister, but there is another error.

Unable to connect to Lenovo-PC(the name of my computer).

With best regards,
Liwei

Hi
Are you using some firewall or similar protection system which could block some ports?
You could check your installation with wmpiconfig.

regards

Hello coulet,

I don't use any firewall, and I reinstall mpich2, it has been sucessfully installed. And I also attached the reslut of wmpiconfig.

BTW, I compile TELEMAC v7p0 parallel manully after the failure of automatic one.I am not sure whether the systel_parallel_v7p0.cfg is correct since I download it from the forum.

With best regards,
Liwei