open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi forum,

I wandered if it was possible to apply a different value of SSC on different nodes of 1 seaboundary as a boundary condition. The SSC values do not vary in time (for now). So for exampe if my boundary has five nodes, I would like to apply a different SSC value to each of these nodes.

I guess if it does not exist yet that I can program it in a subroutine that assigns the values given in the keyword CONCENTRATION PER CLASS AT BOUNDARIES. Which subroutine is responsible for this?

Kind regards,
Sven

Hi Sven,
If I understand well your problem, I think you can. In this case you can define as much boundary as you need and you apply accordingly the values of SSC. The subroutine conlit.f deals with this.

Best wishes,

Pablo

Hi Pablo,

I use sisyphe offline or stand alone. I use the 2D result file of a 3D simulation as hydrodynamic file. Can I use different boundaries as used in the hydrodynamic simulation?
For example in my hydrodynamic simulation I have a seaboundary containing 460 nodes. When I run SISYPHE stand alone with the 2D result file of the hydrodynamic simulation, can I divide this seaboundary in the conlim.cli file of SISYPHE in multiple boundaries and assign a concentration to them with the keyword CONCENTRATION PER CLASS AT BOUNDARIES?

Best regards,

Sven

Hi,
normally that should work.

cheers

pablo