open TELEMAC-MASCARET The mathematically superior suite of solvers

Dear Friends,

I tried to run the coupled telemac-2d and Sisyphe. But my simulation didn't run.

I prepared sisyphe steering file. The boundary condition file, geometry file are all same for both. I had the previous computation file for Telemac2d.

I want to know that, in case of coupling, what command should we run: telemac2d.py ........cas or sisyphe.py........cas?

I tried both ways but resulted in an error in both the cases.

I am also confused about the location of coupling directory. Whether It should be the location where we execute the Telemac2d.py/Sisyphe.py file or else?

Similarly, what should be the results file for Sisyphe and Telemac2d? Whether results of both are stored in a single file or should we give different files for both of them?

I have attached the steering file for both Telemac2d and Sisyphe. Also, the images of the error are attached.

Thank you in advance.

Regards,

Saroj

Hi

You could have a look on the sisyphe example which use the internal coupling to wall understand the method to run the simulation...
Nevertheless, for an internal coupling, you should run Telemac-2D.
In the telemac steering file, the information for coupling are described. In your case, the error is python error (not telemac) and it's just because you add ..\ at the beginning of the sisyphe steering file. As the file are located at the same place (I suppose!) you shouldn't add the prefix to upper level directory.
Depending on what you want to output, each program will produce it's own result file according to what you indicate in each steering file.

Regards

Thank you.

The simulation can now be run.

Hello C.Coulet
I want to find some SISYPHE examples to learn. But I I find none in this website. Could you tell where to search for.

Hello C.Coulet
I want to find some SISYPHE examples to learn. But I I find none in this website. Could you tell where to search for.
What's more, could you tell me in case of coupling, what should I do, and which tool I may use to prepare the input files? And what command should I Run. for telemac2d only, I run "runcode.py telemac2d -s ***.cas"

Hi
The example are not on the website.
You have all of them in the directory where you downloaded telemac.
There is also some example of coupling.
In case of coupling you run telemac2d as usual but in the telemac steering file you declare the coupling with sisyphe

regards