open TELEMAC-MASCARET The mathematically superior suite of solvers

Dear friends,
I am now bothering by this problem. When I am simulating the sediment transport in a meandering river with the telemac2d coupling with the SISYPHE model.Firstly, it runs well, but after twenty minutes, the progress was break down with follow reminding. I have tried several times, all failed in the same way. What's more, I have run the telemac2d only with my mesh,it show well.
Could you give me some suggestions.What should I do to save my simulation?
Best wishes,
Fakai Lei

Hello Lei,

I am not sure what the error is. But you can try one option. First, simulate for twenty minutes and use that result (as previous computation file) to start the next simulation from the end of twenty minutes.

Regards,
Saroj

Dear Karki,
Thank you for your suggestion, I will have a try. I find another bothering phenomenon just now. The same case with the same seting up.I run successfully when I don't use the parallel edit. What's more, the single core edit I use is v7p2, the parallel edit is v7p0. Can this be the reason.
Best wishes,
Fakai Lei