open TELEMAC-MASCARET The mathematically superior suite of solvers

Good morning,
I am using the version v7p2 of TELEMAC and I have built a consolidation model of 20 layers. My problem is that in the results file I am only able to see the first 9.
I have checked the routine "Lecdon_sisyphe", and the number of NCOUCH_TASS is ok; 20; as well as the NLAYMAX. I have also cheked the routine "NOMVAR_SISYPHE", and the number of MAX_VAR and NOMBLAY is still ok. What should I do in order to be able to see the 20 layers of the model?
Thank you very much!

Hi
You should find the location where the result file is written. There is probably some limitation here.

Regards

Hello,

With the v7p2, try to use the following syntax to your "VARIABLES FOR GRAPHIC PRINTOUTS": *ES,**ES,*CONC,**CONC,*A1,**A1

Regards,
Laurent

Thank you about the information!
I have tried to change the name of the output variables, but I still have the first nine layers.
I am trying to see if I find the problem in the routine used to write the results file, and I am looking at BIEF_DESIMP, at the rest seems to look ok. Should I check anywhere else?
Thank you!

Hello,

I saw in the sisyphe dictionary a limitation saying that NCOUCH_TASS should be lower than 10, but it seems to be corrected in the sources.
I tested it quickly from bosse_vase test case, by adding mud consolidation and 20 layers, and it seems working.
Can you share your case please?

Regards,
Laurent