TELEMAC-MASCARET Forum: sisyphe V6.2 crashes by running old simulation done by V6.1 (1/1)

Welcome, Guest

TOPIC: sisyphe V6.2 crashes by running old simulation done by V6.1

sisyphe V6.2 crashes by running old simulation done by V6.1 11 years 10 months ago #7063

gh_river

Hello,

after the end of one project, I have installed TelemacV6.2. Now I am running some simulations with V62 again.
Today I found out, that SisypheV62 crashes with "Problem in Layer, in Layer 1 Sum of Fractions not 1" after 26min (on a case simulated with V61, running for about 12h with a time step of 1s, multiple grain sizes).
I had a look at the layer.f in V62 and changed zero to 10-4, but after 1h 21min Sisyphe V61 crashes again.

Did you make some major changes in the layer.f? I am using the default active layer thickness.

Many thanks,
Gabriele

The administrator has disabled public write access.

sisyphe V6.2 crashes by running old simulation done by V6.1 10 years 11 months ago #11207

Pablo OFFLINE Moderator Posts: 316 Thank you received: 121	Dear Gabriele, sorry for the late response. Did you try to solve this issue with the new version 6.3? Kind regards, Pablo
	The administrator has disabled public write access.

sisyphe V6.2 crashes by running old simulation done by V6.1 10 years 11 months ago #11236

gh_river	Dear Pablo, I am on maternity leave and I had no time until now to test the V6.3. But I will try it in some weeks. Do you think the version 6.3 is better for this kind of case? Best regards, Gabriele
	The administrator has disabled public write access.