open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi,
I received the following message when I set SUSPENSION to YES in the steering file. The model works fine with BED LOAD.



The model also seems to work when I use 8 processors instead of 24. Is this the problem with the mesh or the installation?

Any help would be appreciated. Thanks.

Edwin

Hello,

I think this is a case that has been corrected now, you probably have a sub-domain without boundary node, and the compiler stops because it checks the boundaries of array IKLE which is here meant for boundary nodes and is thus 0. The provisional simpler solution would consist of removing this checking (which must cause you also a loss of efficiency), because there is actually no real mistake and the code would run.

With best regards,

Jean-Michel Hervouet

Thanks. I downloaded, installed the latest codes and no longer have the same problem.

Cheers,

Edwin

Dear, Jean-Michel Hervouet.
sorry to reply here, and disturb you.
but I really need your help.
so please forgive my unexpected question.

Nowdays, I'm working on sediment discharge.
I set my steering file to use 'concentration per class boundaries' and 'sediment discharge'.
but when I didn't use 'sediment discharge',I mean let it blank,
I got same result with simulation that i applied 'sediment discharge value'.
so, I think I made some mistakes. because sediment discharge is not considered, but just concentration.

Could you see my steering file I attached?
If there is any mistake, please let me know.
I hope your generous.
thanks.