open TELEMAC-MASCARET The mathematically superior suite of solvers

Hello,

I have setup a Tomawac-Telemac2D-Sisyphe (v7p0r1) coupled model that runs OK with the HR-VSM, but when I enable C-VSM with the relevant keywords, I getjust after LAYER AFTER BEDLOAD is printed on the listing.

The CSVP example in the repository seems to be based upon an early implementation of the model and is not directly applicable. Are there any additional steps that need to be followed in order to enable C-VSM besides the keywords in the cas file? Are there limitations that need to be obeyed?

Any help would be appreciated.

Regards,
Costas

Dear all,

Problem solved, had to recompile telemac with debug flags in the compiler in order to get clues about what was wrong. It emerged that switching to C-VSM in not as simple as enabling keywords in the steering file. There are additional C-VSM sub-routines that must be used to set it up properly.

Regards,
Costas

Dear Costast,
Could you please upload your C-VSM sub-routines.
Regards
Najib

Hello Najib,

I eventually dropped the C-VSM model and completed the study with the HR-VSM, and unfortunately I deleted the intermediate fortran files.

Regards,
Costas