Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
System Modules
GAIA / SISYPHE
How to set the inlet Qin
Flat Threaded

TOPIC: How to set the inlet Qin

How to set the inlet Qin 9 years 5 months ago #17099

  • harryyao
  • harryyao's Avatar
  • OFFLINE
  • Expert Boarder
  • Posts: 190
  • Thank you received: 3
Dear all,


I am a little bit confuss about the boundary condition set in SISYPHE, I know the boundary condition is the same as the Telemac.

For the bedload and the suspend load in inlet of the river,I think the default value is caluclated by sisyphe. However, If I want to set a specific value (for example set 0 for both bedload and suspended load) for bedload and suspended load at inlet, How should set it ?

Best Regards

harryyao
The administrator has disabled public write access.
Flat Threaded
Moderators: Pablo, pavans
Forum
System Modules
GAIA / SISYPHE
How to set the inlet Qin

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.