TELEMAC-MASCARET Forum: Suspended inflow solid concentration (1/1)

Welcome, Guest

TOPIC: Suspended inflow solid concentration

Suspended inflow solid concentration 9 years 1 month ago #18568

jrma

Hello,

I´m trying to model reservoir with a suspended inflow solid concentration, but I couldn´t set the inflow concentration at the boundary. The results of the simulation show no solid discharge near the upstream boundary condition.
For better understanding I’m attached my files.

Best regards,
JRMA

File Attachment:

File Name: New_Mesh_BC_SIS.cli
File Size: 118 KB

File Attachment:

File Name: New_Mesh_BC_T2D.cli
File Size: 118 KB

File Attachment:

File Name: sis.cas
File Size: 3 KB

File Attachment:

File Name: t2d.cas
File Size: 3 KB

The administrator has disabled public write access.

Suspended inflow solid concentration 9 years 1 month ago #18635

c.coulet OFFLINE Moderator Posts: 3722 Thank you received: 1031	Hi It seems you run the simulation in couple mode. in such case, the boundary condition file used in your simulation is the telemac one. In your case, you have 2 different boundary condition file but the sisyphe one was probably never used. Put the name of the sisyphe one in the telemac steering file and i think this will work Kind regards
	Christophe The administrator has disabled public write access.