Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
Installation
Windows Version
how to run a simulation
Flat Threaded

TOPIC: how to run a simulation

how to run a simulation 5 years 5 months ago #33849

  • geomed
  • geomed's Avatar
Hello everyone, I just installed the TELEMAC MASCARET v8p0 in windows 10, and I think the installation is not complete, so when I tried the compilation test, I get the following message ( see screenshot below), how can I solve this problem?
Attachments:
The administrator has disabled public write access.

how to run a simulation 5 years 4 months ago #33865

  • amanj2013
  • amanj2013's Avatar
  • OFFLINE
  • Expert Boarder
  • Posts: 211
  • Thank you received: 24
Hi,
it seems you have installation problem. Pls upload your config file and as well as a screenshot of your environmental variables to see if everything assigned properly. Are you installing automatic version or manual version? have also a right click on telemac icon and then properties and then copy the target line and paste her to see if its properly defined or not.

AMANJ
The administrator has disabled public write access.

how to run a simulation 5 years 4 months ago #33993

  • jose2kk
  • jose2kk's Avatar
  • OFFLINE
  • Expert Boarder
  • Posts: 161
  • Thank you received: 59
Hello,

Sorry for this late reply.

It looks like you did not have a successful installation. Nevertheless, it could also be a problem with the configuration file. I would redo the installation and take care of paths configuration.

I hope this helps.

Best Regards,
José Andrés.
The administrator has disabled public write access.
Flat Threaded
Moderators: borisb
Forum
Installation
Windows Version
how to run a simulation

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.