open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi everyone,

I am trying to install Telemac v7p2r1 on my computer (Windows10) I followed the installation guide by José Andrés Morales. (By the way, thank you for your really clear tutorial, if you read this topic !)
It worked easily for the scalar version but i had to face a lot of problem with the parallel version.
After modifying the tutorial systel file several times, compileTELEMAC.py suceed with the systel file attached.

And then, to test it, I tried to run a simulation and it failed with 3 error pop-ups like on the attached picture. The mistake messages are :

code execution cannot proceed because libgcc_s_seh-1.dll was not found. Reinstalling the program may fix this problem.

the code execution cannot proceed because libgfortran-3.dll was not found. Reinstalling the program may fix this problem.

the code execution cannot proceed because fmpich2g.dll was not found. Reinstalling the program may fix this problem.

I did some google researches and i tried to add the paths to the lib in my PATH. I also tried to add "-static-libgcc -static-libstdc++" in the systel_file at cmd_obj or cmd_lib lines and compile again but it didn't solve the problem.
(source : stackoverflow.com/questions/4702732/the-...dw2-1-dll-is-missing)

Also, I don't have the file fmpich2g.dll on my computer.

I am a beginner and it is the first time I am (trying to) installing and using Telemac.

I hope you have a solution to this problem, thank you,

Antoine.