TELEMAC-MASCARET Forum: Telemac2d output (1/1)

Welcome, Guest

TOPIC: Telemac2d output

Telemac2d output 6 years 1 month ago #31744

TheGunslinger

Hello everybody,

I have a question.

In Telemac3d manual, we can see that there is the possibility to use a lot of turbulence models, for example Mixing Length and K-epsilon.

In Telemac2d manual, we cannot choose Mixing Length.

We know that the 3d simulation gives also the 2d results as output.

So, my question is: if we launch a 3d simulation with ML model, which is the model that the software use for 2d?

Thanks

The administrator has disabled public write access.

Telemac2d output 6 years 1 month ago #31745

c.coulet OFFLINE Moderator Posts: 3722 Thank you received: 1031	Hi If you read the telemac3d manual you will see that the 2D results is just an average of the 3D values... This is not a 2D run of your model! You run a 3D simulation with ML model then the model use is ML.
	Christophe The administrator has disabled public write access. The following user(s) said Thank You: TheGunslinger