open TELEMAC-MASCARET The mathematically superior suite of solvers

hello,I am a newer for learning the telemac software,when I follow the tutorial [url=http://]http://www.opentelemac.org/index.php/component/jdownloads/summary/4-training-and-tutorials/185-telemac-2d-tutorial?Itemid=55[/url]
,before the section 3.4 ,the excecise results are all ok. but when I do the steps(section 3.4 interpolate bathymetry to mesh) ,then the result is not same with the turotial section 3.4.
My actual results is shown below the attach picture,which the elevation values are the same.

Although I have find the releated topic(maybe it could help me ) in the Bluekenue , I have not deal with the problem.
could anyone point out the problems where I am wrong?
Thank a lot.

Hi
Did you check the color scale and the data on your mesh after the interpolation?
Regards

Did you say the color scale of newmesh? I capture the picture shouwn below. the parameters needs to be modify？
Thank you！

Yes
Your color ramp is between 0 and 1 and the values between 6 and 38 so it's logical to see the mesh entirely in red!

reset the color scale and you will probably solve your problem

Regards

It displays very well.
Thank you very much.