TELEMAC-MASCARET Forum: Mesh model for a marine submersion study (1/1)

Welcome, Guest

TOPIC: Mesh model for a marine submersion study

Mesh model for a marine submersion study 6 years 3 months ago #31189

JF

Hi everyone!

I'm a beginner in bluekenue and in Telemac2d. I work on marine submersion project (Seine-maritime-coast).I built a mesh with bathymetry and land mnt because I want to see the tide effect for extrem levels in lands. I would like to check with you if its ok. And then I want to fix boundaries conditions like in blue kenue note but I can't chose the condition line that i want. the software only allows me to select the purple line. And I would like to select the other side. Any ideas?

Best regards

Julien

Attachments:

FOND.jpg (483KB)
BC3.jpg (306KB)

The administrator has disabled public write access.

Mesh model for a marine submersion study 6 years 3 months ago #31190

c.coulet OFFLINE Moderator Posts: 3722 Thank you received: 1031	Hi On the second point, I don't know if a solution exist to select the other side. BK choose in fact the side with the smallest number of node... You could overpass this problem by dividing the boundary condition in 2 parts with only few nodes between both and at the end, manually edit the cli file and change the characteristics of the node between the 2 boundaries... Regards
	Christophe The administrator has disabled public write access. The following user(s) said Thank You: JF