Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
PRE/POST PROCESSORS
Blue Kenue
Meshing a hole based on an existing mesh (without a bathymety file)
Flat Threaded

TOPIC: Meshing a hole based on an existing mesh (without a bathymety file)

Meshing a hole based on an existing mesh (without a bathymety file) 3 years 6 months ago #38525

Hello,

I am new to BlueKenue. I have an existing mesh with some holes (corresponding to buildings polygons) and I would like to mesh these void polygons. I don't have the bathymety data.. so I think that I can't use the 2Dinterpolator.

I can mesh these holes but I need to assign elevation values (depending on the elevations of the nodes of the polygons)


Could anyone help me please ?


Thanks
The administrator has disabled public write access.

Meshing a hole based on an existing mesh (without a bathymety file) 3 years 6 months ago #38527

I found a solution for my question. I had to export bathymetry data from the existing mesh as an XYZ file. Then, put these data in a interpolator2D and map the hole to them. Hope this helps any future lecturer.
The administrator has disabled public write access.
The following user(s) said Thank You: a.barton
Flat Threaded
Moderators: Serrer, a.barton
Forum
PRE/POST PROCESSORS
Blue Kenue
Meshing a hole based on an existing mesh (without a bathymety file)

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.