TELEMAC-MASCARET Forum: Error while run the T3 Mesh Generator (1/1)

Welcome, Guest

TOPIC: Error while run the T3 Mesh Generator

Error while run the T3 Mesh Generator 3 years 4 months ago #38722

noorashiekin

Hi everyone,

I would ask anyone who knows how to solve my problem. I have drawn the shoreline(closed line in i2s file) and drag into the outline but during mesh generating, the error has been popup. I have screenshot the error. I have been checked no duplicate nodes in the closed line.

Picture 1: If I put default edge length =1, ERROR: while triangulating nodes.
Picture 2: If I put default edge length greater than 5, ERROR: finding outline from the resampled set.

Thank you

Attachment DefaultEdgeLength1.jpg not found

Attachment DefaultEdgeLength5.jpg not found

The administrator has disabled public write access.

Error while run the T3 Mesh Generator 3 years 4 months ago #38725

c.coulet OFFLINE Moderator Posts: 3722 Thank you received: 1031	Hi The edge length you gave is greater than the values of your data. The value should be given according to your data which here are in degrees... Give the outline in UTM would be help you to fix this problem Regards
	Christophe The administrator has disabled public write access. The following user(s) said Thank You: a.barton, noorashiekin