TELEMAC-MASCARET Forum: Hole in the mesh (1/1)

Welcome, Guest

TOPIC: Hole in the mesh

Hole in the mesh 11 years 7 months ago #8162

dieval	Hello, I generated a mesh from several sub mesh. Then I created a final mesh of my field of study. By placing the boundary conditions, a hole appears in the mesh. My question is the following: Is there a way to redo the mesh locally. Currently, I only have slf file. cordially File Attachment: File Name: probleme_maillage.pdf File Size: 265 KB
	The administrator has disabled public write access.

Hole in the mesh 11 years 7 months ago #8163

dieval	The following method is the right one: 1 - Creating a mesh hole based on the mesh nodes 2 - Merge: Edit -> T3-Mesh -> Merge Mesh ... 3 - Backup and create a mesh TELEMAC
	The administrator has disabled public write access.

Hole in the mesh 11 years 7 months ago #8164

Serrer OFFLINE Moderator Posts: 720 Thank you received: 304	Hi, The boundary conditions editor should NOT be creating a hole in your mesh. This is very strange... Please describe your workflow in detail and post the data files. Page 28 of the Blue Kenue tutorial describes local mesh refinement. Martin
	The administrator has disabled public write access. The following user(s) said Thank You: dieval

Hole in the mesh 11 years 7 months ago #8173

c.coulet
OFFLINE
Moderator
Posts: 3722
Thank you received: 1031

Hi
Short correction on this topic

This is not the management of boundary conditions which could create a hole in your mesh.
But in fact, during the management of boundaries in Fudaa, it's possible to see the holes in the mesh which has been previously unseen during the mesh creation.

This often appear when you generate mesh from several submesh if you don't take care to the interface.

The solution, is OK

Christophe

The administrator has disabled public write access.

The following user(s) said Thank You: dieval