TELEMAC-MASCARET Forum: ERROR OF NUMBERING IN THE ELEMENT (1/1)

Welcome, Guest

TOPIC: ERROR OF NUMBERING IN THE ELEMENT

ERROR OF NUMBERING IN THE ELEMENT 11 years 5 months ago #8997

hong

Hi,there.

The following error message kept rising up:

ELEBD: ERROR OF NUMBERING IN THE ELEMENT:2147483647
POSSIBLE REASON:
THE BOUNDARY CONDITION FILE IS NOT
RELEVANT TO THE GEOMETRY FILE

I regenerated geo fiel and bc file several times and be sure they match ,but still doesn't work.

Could someone please give me some hint about the problem?

Please see attached geo file and bc file.

Best wishes

Attachments:

bc-new.cli (129KB)

The administrator has disabled public write access.

ERROR OF NUMBERING IN THE ELEMENT 11 years 5 months ago #9005

c.coulet OFFLINE Moderator Posts: 3722 Thank you received: 1031	Hi Maybe a problem of binary file format in the geometry? Did you choose big-endian when you generate it? Regards
	Christophe The administrator has disabled public write access.

ERROR OF NUMBERING IN THE ELEMENT 11 years 5 months ago #9019

ewang OFFLINE Senior Boarder Posts: 100	My experience with this problem is with the mesh. Do you have any island in your mesh? Usually my problem node is near where the island is. Edwin
	The administrator has disabled public write access.

ERROR OF NUMBERING IN THE ELEMENT 11 years 5 months ago #9149

hong	Thank you all. I have found a very inconspicuous mistake in the mesh and overcome the problem:)
	The administrator has disabled public write access.

ERROR OF NUMBERING IN THE ELEMENT 11 years 4 months ago #9807

minmin	hong wrote: Thank you all. I have found a very inconspicuous mistake in the mesh and overcome the problem:) I have met the same problem, can you tell me what is the inconspicuous mistake?thank you!
	The administrator has disabled public write access.

ERROR OF NUMBERING IN THE ELEMENT 11 years 3 months ago #9840

hong	It were some useless lines
	The administrator has disabled public write access.

ERROR OF NUMBERING IN THE ELEMENT 11 years 3 months ago #9842

minmin	do you mean there is some useless lines in the wrong mesh? but i do from the very beginning, only one channel,three lines: the right bank ,left bank and the thalweg. the generated mesh only added the boundary. i still met the problem, can you give me some advice? thank you very much for your reply!
	The administrator has disabled public write access.

ERROR OF NUMBERING IN THE ELEMENT 11 years 3 months ago #9957

hong	Yes, after I deleted the wrong line and regenerated the mesh, everything was Ok then. Can you upload a picuture of your mesh?
	The administrator has disabled public write access.

ERROR OF NUMBERING IN THE ELEMENT 11 years 3 months ago #10106

minmin	Thank you for your reply.I have set different default edge length, but few can run correctly, the most frequency result is the boundary condition file is not relevant to the geometry file. here in the attachment, i set the default edge length as 50 Attachments: h452c005.jpg (125KB)
	The administrator has disabled public write access.

ERROR OF NUMBERING IN THE ELEMENT 11 years 2 months ago #10120

hong	What do you mean by saying "the boundary condition file is not relevant to the geometry file"? Would you please explain?
	The administrator has disabled public write access.