TELEMAC-MASCARET Forum: results / post-processor's capabilities (1/1)

Welcome, Guest

TOPIC: results / post-processor's capabilities

results / post-processor's capabilities 10 years 7 months ago #12541

Matta

Hi!
I am at the first approaches with Telemac. I started with the first simulations of the flow in a bay that I am studying in Brazil.
I am wondering, if with Blue Kenue or with some other post-processor (for example Davit) is possible to get the following values:
- mean depth
- surface area
- bottom area
- volume
- surface area and volume at each water depth
ONLY FOR A SPECIFIC PART of the whole domain.

Thank you for any help/suggestion you could give me!

The administrator has disabled public write access.

results / post-processor's capabilities 10 years 7 months ago #12548

Serrer OFFLINE Moderator Posts: 720 Thank you received: 304	Hi Matta, For average values in a polygon Have a look at "Tools->Extract TimeSeries->Constrained By" For Areas and Volumes "Tools->T3 Mesh->Extract Subset.." then "Tools->Compute Area" "Tools->Compute Volume" Hope this helps... Martin
	The administrator has disabled public write access. The following user(s) said Thank You: Matta

results / post-processor's capabilities 10 years 7 months ago #12550

Matta	Thank you, I would try! I have another quick question, do you think I could do it also with Paraview? Because at work I have Linux and so I cannot use Blue Keneu... Thanks again.
	The administrator has disabled public write access.

results / post-processor's capabilities 10 years 7 months ago #12551

Serrer OFFLINE Moderator Posts: 720 Thank you received: 304	I'm afraid I don't know Paraview. Have you tried installing Blue Kenue on Linux under WINE? www.winehq.org/ Cheers... Martin
	The administrator has disabled public write access. The following user(s) said Thank You: Matta