Error while defining more than 4 discharge source

System Modules TELEMAC-2D
21

Hi [name removed],

unfortunately I cannot really help with the compilation. I always failed installing the API on Windows…

You can try using the guide here to install:

https://gitlab.pam-retd.fr/otm/wintel

Otherwise, this might be a new issue and you could open a new thread (installation issue)

[name removed]

1 Like
22

Hi

You don’t have to declare MAXSCE as a parameter in lecdon_telemac2d.f

Just give the value in the steering file in the keyword:

MAXIMUM NUMBER OF SOURCES = xxx

In lecdon you should replace the reading of the steering file for the location, the discharge and if needed, the tracer concentration…

regards

1 Like
23

Hello,

This is an update with regards to what I was able to simulate and compile.

Based on what [name removed] and Christophie had suggested and also from this post https://www.opentelemac.org/index.php/kunena/16-telemac-2d/13303-limit-in-maxkeyword?start=20#46160, I was able to recompile telemac and run the simulations.

However, while recompiling I did always run into the api error where the recompilation would always fail and I could not fix it (running on Windows). So I recompiled WITHOUT the api section in the config file.

Thank you for your help :slight_smile:

[name removed]