Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
System Modules
TELEMAC-2D
ill-posed problem
Flat Threaded
  • Page:
  • 1
  • 2

TOPIC: ill-posed problem

ill-posed problem 2 years 1 month ago #41273

  • c.coulet
  • c.coulet's Avatar
  • OFFLINE
  • Moderator
  • Posts: 3722
  • Thank you received: 1031
What is the bottom level?
What is the imposed value?
Why are you mentionning tomawac?
Christophe
The administrator has disabled public write access.

ill-posed problem 2 years 1 month ago #41274

  • geo_t
  • geo_t's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 9
Sorry I didnt refer that this is a coupled simulation between tomawac and telemac. i havent impose any velocity values. In that node the bottom level is -1m. The whole domain is between 0 to -100m.

Thank you again.
Best regards,
Georgia
The administrator has disabled public write access.

ill-posed problem 2 years 1 month ago #41275

  • c.coulet
  • c.coulet's Avatar
  • OFFLINE
  • Moderator
  • Posts: 3722
  • Thank you received: 1031
Even it's a coupled simulation, you should impose some values in telemac...
What are the water level imposed values on the 2 liquid boundaries?
Christophe
The administrator has disabled public write access.

ill-posed problem 2 years 1 month ago #41276

  • geo_t
  • geo_t's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 9
In telemac I chose
INITIAL CONDITIONS : 'ZERO ELEVATION'
PRESCRIBED ELEVATIONS : 0

I havent impose any values besides the prescribed H.
The administrator has disabled public write access.
Flat Threaded
  • Page:
  • 1
  • 2
Moderators: pham
Forum
System Modules
TELEMAC-2D
ill-posed problem

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.