open TELEMAC-MASCARET The mathematically superior suite of solvers

Hello

From what i see in your fortran user, littoral should not be an example for you. I think you can do something simpler. Can you send your full case i will see what can be done from it.

best regards

T.

Hi!
Thanks for the reply!

I attached to you the folder with all my file.
There is the tomawac cas file. Inside there is also the telemac2d for the coupling but don't work very well...

if you have to ask me somethings i'm here.

R

Hello

I worked on the user_fortran limwac of case Manche to make it works in parallel (not pushed yet). Seeing your case, it should work with you.

I attach the file ...

Hope it helps

regards

T.

sorry wrong file

Hi,
Thanks a lot!
Now the Manche case works very fine in parallel!
Thank you!
Now I would try coupl whit telemac3d in parallel! I will say to you if I will succeed.

R

hi,
I tryed to use the file limwac for the parallel in my case but the results are very bad.
Why it don't work when i change the geometry file and the relative file .lar??
Thanks
R

these are all the files.

Hello,
I think that the problem comes from your file mareggiata170.lar we do not follow the same logic. Try to change the points recorded. 106 instead of 100 and 5140 instead of 5150 (they are extremity of your boundary condition 5 4 4). otherwise the interpolation is not good.

Hope it helps

T.

Hi,
mareggiata170.lar is built in the same way of the file lar of manche example.
The results are very good in scalar mode but not in parallel.
I don't think is this the problem. However I'm trying now.

thanks

R