open TELEMAC-MASCARET The mathematically superior suite of solvers

Dear Lea,

A few remarks:

• Set PRISE EN COMPTE DE LA PROPAGATION =true
• Change the delimiter in your winds file from ";" to ","
• Set LINEAR WAVE GENERATION = 1 (Translate as necessary)
• Sort out the wave conditions at the open boundaries. Else you can set everything to solid in your cli (222) to get you started

Regards,
Costas

Dear Costas,
My model is know working, but it only read the first timestep of the windfile. I think it is because of the venuti subroutine but I cannot manage to understand what is causing this problem..Here is the result file.

Regards,
Léa

Dear Lea,

It reads the first timestep only because your computation spans between the first entries in your winds file. Try 1000 timesteps instead of 100.

Regards,
Costas

Dear Costas,
Thank you for all your advices. I think the issue still remains, the model only read the first timestep. What could possibly cause that problem?
Regards,
Léa

Dear Lea,

Can you post the listing output of the model run? Use console redirection to capture it in a text file.

Costas

Dear Costas,
I am sorry but what do you mean by "listing output of the model run"? Do you need the result file?
I join the listing that tomawac shows during the computation, but I am not sure that what you meant by "listing output".

Léa

That is the output listing! Can you also attach the results you got from this run?

Costas

Ok! Here is my result.
Regards,
Léa

I exported the result data via Fudaa Prepro because I did not succeed to join my result fil.

Hello Lea, there are no results attached. Probable you should zip them first.

Regards,
Costas