open TELEMAC-MASCARET The mathematically superior suite of solvers

I tried to install the new version v7p2. I had no problem to compile.py but when i tried to run a cas, I got the problem in the attachments. This case worked well with the version v7p0. It's possible that the problem was caused by the config file so i joined it.
Thanks for answers
Faithfully
JBS

Hi JBS,

I got exact the same error when running an example case in V7p2 with Intel compiler 13. Did you already solve the problem?

Regards,

Yunhao

Hello Yunhao,
I found a solution to my problem. I don't know why but my version V7P2 worked well when my case got a fortran file (I just take a fortran file from source without modify it) but crashed for a case without fortran file like in the exemple case.
So I must verify this point for a huge number of case but it seems to work for me.
I hope this solution will work for you.
Regards,
JBS

Hi JBS,

Thanks for your quick reply, unfortunately this doesn't work with me, but could you share some detailed information during the V7p2 installation? Like Windows 7 or 10, automatic or manual installation, type of compiler? Thanks!

Best regards,
Yunhao

What error did you get when adding a user fortran ?

Hi Yoann,

I've solved the problem and been able to run simulations in scalar mode with v7p2r1, but the parallel mode still doesn't work, as shown in the attachment. I checked the mpi and it is registered. Do you know how to solve this? I really need the parallel mode to accelerate my case.

Thanks in advance.

Best regards,
Yunhao

Could you try to run the command that is displayed just on top of telemac3d from the temporary folder.

Hi Yoann,

Thanks for your reply, I tried to run the out_t3d_malpasset in the temporary folder and the error is below:



Yunhao

Could you post the full listing ?
try adding > listing.txt at the end of the command to redirect it into a file.

Thanks.

Hi Yoann,

Please find the full listing in the attachment.

Thanks!