Welcome, Guest
Username: Password: Remember me
  • Page:
  • 1
  • 2

TOPIC: fudaa pre-pro

fudaa pre-pro 8 years 10 months ago #19121

  • Murru
  • Murru's Avatar
I opened a steering file. Thank you for your advice ;) when I launch the compuation, fudaa creates a .fzip file and not a .res file!Is that normal?what should it create after a computation?
Thank you so much
The administrator has disabled public write access.

fudaa pre-pro 8 years 10 months ago #19123

  • c.coulet
  • c.coulet's Avatar
  • OFFLINE
  • Moderator
  • Posts: 3722
  • Thank you received: 1031
The fzip file is a fudaa file where some specific information are stored. But this is only for fudaa and have no use in telemac.
if no result file are created, this means there is a problem with the computation and probably more with the computation launch.
As I already wrote here, you should run telemac (or probably artemis in your case) outside of fudaa to avoid any configuration problem linked to fudaa.
Just open a DOS windows and run the module directly in command line. Something like:
artemis.py name_of_steering_file

Regards
Christophe
The administrator has disabled public write access.

fudaa pre-pro 8 years 10 months ago #19126

  • Murru
  • Murru's Avatar
Finally I get it, you clarify my doubts. My problem is in the telemac installation I supposed.Cause when I run an example of telemac, the simulation seems incompleted.(see file attached). It teminated with .exe file and stop.
What's wrong?
When I made the installation with python procedure, the compileTELEMAC.py was ok, in fact terminated with "My work is done".But after when I Run TELEMAC from the command line seems unfinished and it does NOT appear "My work is done".

Thank you again C.Coulet
Attachments:
The administrator has disabled public write access.

fudaa pre-pro 8 years 10 months ago #19199

  • Murru
  • Murru's Avatar
Hello,
Finally telemac works, when I run an example is fine and appears "My work is done". I have always the problem with fudaa pre-pro. I don't have any results file when I run the computation. What can I do?

Thank you

Ste
The administrator has disabled public write access.

fudaa pre-pro 8 years 10 months ago #19201

  • c.coulet
  • c.coulet's Avatar
  • OFFLINE
  • Moderator
  • Posts: 3722
  • Thank you received: 1031
Hi Stephanie

If you ran your example outside fudaa, it's a good news.
You can do that for all your simulations and forgot to try to run the simulation from the fudaa interface.

In fudaa, you could just analyze the results created by opening it with the post module.

Kind regards
Christophe
The administrator has disabled public write access.

fudaa pre-pro 7 years 3 months ago #27123

  • wafaa93
  • wafaa93's Avatar
please can you help me
when i do a right click on the geometry file, the create a telemac project doesn't appear ?
here's what i got
what should i do
regards
Attachments:
The administrator has disabled public write access.
  • Page:
  • 1
  • 2

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.