open TELEMAC-MASCARET The mathematically superior suite of solvers

Ok I know what my mistake was : the name of my systel file is systel_ v8p1 not systel_v8p1... and I wrote the wrong systel'name in my Target box path.

Now the compilation is carrying on.

Thanks all for your help and sorry again Andrea

Does anyone knows if the parallele instaltion is automatically complete with the manually installation guide (wiki.opentelemac.org/doku.php?id=instruc...tomatic_installation) ?

I never installed it, but I think you have to repeat the steps using the systel_parallel configuration file

You config file (systel_v8r1.cfg) only installs the scalar version (win7gfors).
You can add the configuration for parallel (wing64mpi) to this file and then change the line 5:
configs: win7gfors wing64mpi

Then it will install both when you run compile_telemac.py.

Hope that helps,

Patrick

Ok thanks, the complitaion worked

But when I tried an example from cmd :
cd examples\telemac2d\malpasset
telemac2d.py t2d_malpasset-fine.cas

The simulation failed (see Capture) and I don't know why ...​

BTW I didn't succeed in the installation of the pre-requieres during the automatic installation especially mpich2, maybe it's linked

Without mpich2 your parallel configuration is not working.

What command are you using? Does the scalar version (win7gfors) run the example correctly?

There are subjects on the forum for troubleshooting the mpich2 installation. Correct installation and user authentication can be verified by the command «mpiexec -validate»

I don't think that the scalar version (win7gfors) run the example either. I think the key is the pre-installation problems. I'm gonna check the forum for troubleshooting the installation' problems.

Thanks