open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi Ruli,

It seems now that you don't have any sediment in your domain during the whole simulation. Are you sure you're prescribing concentration in the right way? (imposed tracer code LITBOR=5 in your conlim file).
Can you provide your conlim and geometry files also please?

(Also, you're time step seems to be too high for your flow computation)

Regards,
Laurent

Thanks for your quick respond








couldnot upload until zipping it


that might be the reason of the problem?




I will try with lower values for time step now.

I think the problem was LITBOR=5 as I changed the numbers from 4 to 5 for boundary points.






Thank you very much

Yes, I confirm.
In attachment, I slightly modified your steering and conlim files. I removed useless keywords and add others that you should use for sediment computation.



Good luck

Regards,
Laurent

Very nice of you.

a quick question regarding the .cli file, you have changed one of the boundaries, is it ok? or both of them should be with number 5?

thanks

You can try with free tracer values on the outflow boundary, and wait for your flow reaches the outflow boundary to see what happens (end of the spin-up period). It should be good like this, but otherwise you can try to also prescribe it.
Anyway, it should not have too much influence on your calculation as it's on the outflow boundary.

Regards,
Laurent