TELEMAC-MASCARET Forum: Practical Applications of ARTEMIS (2/2)

Welcome, Guest

TOPIC: Practical Applications of ARTEMIS

Practical Applications of ARTEMIS 3 years 2 weeks ago #40033

toby.jhnsn OFFLINE Expert Boarder Posts: 161 Thank you received: 8	Hi Costas, I adjusted the CLI file so that the wave boundary along the west and south was sequentially numbered all the way around but it didn't seem to make any difference. The water depth is constant around the model boundary. Also tried increasing the water depth another 20 m but the shadowing effects were still present. Regards,
	The administrator has disabled public write access.

Practical Applications of ARTEMIS 3 years 2 weeks ago #40036

cyamin OFFLINE openTELEMAC Guru Posts: 997 Thank you received: 234	Hi Toby, did you manage to sort it out? I have some further things to test, I hope to spare some time later on today. Costas
	The administrator has disabled public write access.

Practical Applications of ARTEMIS 3 years 2 weeks ago #40037

toby.jhnsn
OFFLINE
Expert Boarder
Posts: 161
Thank you received: 8

Hi Costas,

Unfortunately I wasn't able to resolve the issue and due to time constraints I've opted to switch to SWASH on this particular job. I would still like to try and resolve the issue though as I'm hoping to be able to use ARTEMIS for future projects.

Also struggling a bit with the grid resolution requirements on this particular project. The site is mostly exposed to low-period wind-waves which requires a very fine grid resolution (1-2 m) to meet the minimum 5-7 grid point per wavelength requirement. As the model only runs in scalar this is leading to rather long run-times.

Thanks again for your help.

The administrator has disabled public write access.