open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi everyone,

Could someone share your experience in using post processors to read TELEMAC 3D output-files? I mean which one is easiest ones to install and use, of course it is a free version? I have read PARAVIEW installation procedure on this forum, but it is probably not easy Techplot is a commercial program, not free

Thank you so much for any sharing experience!

Best Regards

HUY

Hello,

Well you can try to install Paraview, it is really a powerful software, and in the future user interface for Telemac prepared at EDF (called Salomé) it will be available, so learning to use it is not lost time.

With best regards,

Jean-Michel Hervouet

Thanks JMH,

If there is no way to go, I have to try.

Best Regards

Huy