Parallels and Tomawac don't work properly

System Modules TOMAWAC
1

Hi [name removed] .

I am no more able to run a simulation with all 4 cores of my desktop. Also when I run tomawac simulations (alone or coupling) it is very slower than previously. [name removed] and t3d+Gaia work correctly but only on ncsize 1 or 2 .

I thought it was a problem of a shut down that happen during a simulation, so I reinstalled v8p4 alongaide with ubuntu20.04 like previously installed on an other desktop with similar caracteristics and same problem. I also upgrade to v9p0 with ubuntu 22.04 on the pc receiving the shut down and same problem.

Thanks for your help.

[name removed]

2

Hard to say with only this small description…

3

hi [name removed],

thanx for repplying, sorry for not sharing the files

here attached the log problem, my pc specification , my htop showing 4 runiing when I requested 2, the cas files , the wind file, the uv and h file required for the t3d-tpxo cannot pass here, but I think [name removed] got it and already shared the files with you or the moderator.

and I think I have been blocked for some files, I cannot even share the slf Ishare the minimum

thx for your help

CAS_T3D_TOM_G_REDACS_LAST.txt (9.36 KB)
tom_hypo_pasp_REDACS_LAST.cas (5.5 KB)
PROBLEM_PARALLEL_TOM.txt (4.83 KB)
vent_test0_dec15.csv (1.36 KB)
LASTBCPASP5664F4554.cli (23.4 KB)

4

Hi

What we could see in your log show a problem, not at the computation step but a problem at the partitioning step of the GEO file…

Other point, I don’t understand the point of request 2 procs

Regards