Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
System Modules
TELEMAC-2D
Erreur : Point solide entre deux points liquides
Flat Threaded
  • Page:
  • 1
  • 2

TOPIC: Erreur : Point solide entre deux points liquides

Erreur : Point solide entre deux points liquides 7 years 8 months ago #25738

  • c.coulet
  • c.coulet's Avatar
  • OFFLINE
  • Moderator
  • Posts: 3722
  • Thank you received: 1031
I was wrong
You need to have 2 dry points between 2 liquids boundary...

You should also change you steering file as you initial condition is too low and then the boundaries where you prescribed discharge is dry...

Regards
Christophe
The administrator has disabled public write access.

Erreur : Point solide entre deux points liquides 7 years 8 months ago #25739

  • Nicolas Sadoch
  • Nicolas Sadoch's Avatar
OK, will do and confirm.

Thanks a bunch!
The administrator has disabled public write access.

Erreur : Point solide entre deux points liquides 7 years 8 months ago #25741

  • jmhervouet
  • jmhervouet's Avatar
Hello,

Only one solid node is not sufficient, because a segment between a solid node and a liquid node is considered liquid. To really have one solid segment representing a wall you need at least two solid points, this is why Telemac complains.

With best regards,

Jean-Michel Hervouet
The administrator has disabled public write access.

Erreur : Point solide entre deux points liquides 7 years 8 months ago #25742

  • Nicolas Sadoch
  • Nicolas Sadoch's Avatar
Yes! It isworking now that I did the correction.

Thank you guys!
Nicolas.
The administrator has disabled public write access.
Flat Threaded
  • Page:
  • 1
  • 2
Moderators: pham
Forum
System Modules
TELEMAC-2D
Erreur : Point solide entre deux points liquides

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.