open TELEMAC-MASCARET The mathematically superior suite of solvers

Hello everyone!

I am using the v8p4 version of TELEMAC2D and have encountered a problem. In my simulation case, there are 358 outflow boundaries. When the simulation startes, an error message "ADRESS GREATER THAN NMAX=300" (as shown in the figure) appeared. I suspect that this is due to the "OPTION FOR LIQUID BOUNDARIES" parameter in my cas file being too long. As I have over 300 open boundaries, and I want to set each one to the Thompson method, the "OPTION FOR LIQUID BOUNDARIES" parameter needs over 300 "2"s to be set. However, I have not found any place in the source code where I can modify the NMAX parameter. How can I solve this problem?

Thank you very much!

Hello,

You should use the search feature of this forum, the issue has already been answered a few times, see e.g.:
www.opentelemac.org/index.php/kunena/21-...rror-telemac3d#38254

Hope this helps,

Chi-Tuan

Hello pham,

I think my problem is that I didn't run compile_telemac.py with --clean option.

Tahnk you very much!

Hi
Excuse me,I installed V8P4 with the auto-installer and I'm having a problem like yours too.But I don't know how to make a full clean compilation of telemac.So could you tell me how to do it.Thank you so much!!

Best wishes