open TELEMAC-MASCARET The mathematically superior suite of solvers

Hey, I'm trying to run telemac 2d by the command prompt, but keep getting error notifications as shown above,



Is it because my .cas file is not correct and missing parameters?

Thank you!

Hi
According to screenshot, this is a MPI problem...
Hard to say more

Hey, I have reinstalled MPI, but still have the same error notification.

And I also found after opening my .cas file with notepad, there are some differences between my .cas and the one in the tutorial. For example, I don't have the timestep parameter after I generate my .cas file. Does it mean sth was wrong when I ran the FUDAA ?

Hi
FUDAA is no longer maintained and then it's not recommended to use it to build steering files...
By default timestep is set to 1 then this is not a huge problem if you don't have it in your steering file...
To chech if this is really realted to MPI or Telemac, try to run your case in sequential mode

Hope this helps

Thank you very much!

I just followed the steps in the tutorial and used fudaa.

Is there any other software to build steering files?

Which tutorial did you use?
Sorry but no other solution for steering file.
Most part of users start from an existing steering file (from previous studies or Telemac example) an only edit it with a simple text editor

Regards

v6p3 but I will take your advice to use the example .cas file!

Thank you so much!