|
Welcome,
Guest
|
TOPIC: Simulation fails when running with prescribed SSC at inlets
Simulation fails when running with prescribed SSC at inlets 1 month 1 week ago #45719
|
Dear everyone,
I'm running a simulation where I need to impose suspended sediment concentration (SSC) at one or both of the inflow boundaries (two incoming flows merging with both bedload and suspended load activated). So far, I've successfully run the case of equilibrium bed at the inlets. However, when I switch to imposing SSC at the inlets, the simulation fails with the error messages as attached. I've tried many different settings (e.g., de-activating bedload, prescribing SSC in the .cli file, ...), but this error persists anyhow. A related question is that can we set two different conditions for the two inflow boundaries? For example, can I set an equilibrium condition for an inlet while having an imposed SSC at the other? If yes, should I set EQUILIBRIUM INFLOW CONCENTRATION = NO, otherwise it's going to overwrite the prescribed SSC values? I wonder if anyone would know what went wrong or anything about this. I've attached all files here (in the following post). I'd really appreciate any insight... Thank you so much! Jason
Attachments:
|
|
|
Simulation fails when running with prescribed SSC at inlets 1 month 1 week ago #45720
|
Somehow the file attachment didn't go through...
Attachments:
|
|
|
Simulation fails when running with prescribed SSC at inlets 1 month 6 days ago #45729
|
I noticed that, for some reason, the file for the hot start wouldn't go through... (r2d_oldbridge.slf specified in my cas file). It's basically just telemac2d run for 6.5hrs to steady state without coupled with gaia.
I include screenshots of inflow BCs from the user's manual here (I'm using v8p3r0). Sorry for the recurrent posts.
Attachments:
|
|
|
