open TELEMAC-MASCARET The mathematically superior suite of solvers

Dear friends, the form bag concrete is used for slope protection below ▽ 10.0, and the square lattice skeleton is used for slope protection above ▽ 10.0. As shown in the figure, how to set the local non-erodible thickness in this case?
Best wishes

Hi Abandoned,

This is a frequent question. The simplest solution I'm aware of is by using user_bed_init and a locally modified bottom roughness: #41943

For sure, a simpler version (such as a LAYER THICKNESS variable that can be added when creating the Selafin) would be an excellent addition to the GAIA codebase, if it hasn't been added already in v9p0.

Hope this helps,
André Renault

Dear friend
Hello, could you tell me how to a layer thickness variable that can be added when creating the selafin? I don't see the variable layer thickness in bluekenue.
Thank you！