TELEMAC-MASCARET Forum: TOMAWAC boundary conditions when having water level and current files (1/1)

Welcome, Guest

TOPIC: TOMAWAC boundary conditions when having water level and current files

TOMAWAC boundary conditions when having water level and current files 2 years 11 months ago #39365

NZrigat
OFFLINE
Senior Boarder
Posts: 65
Thank you received: 16

Hi All,

I have successfully imported tidal water level and currents files from a previous TELEMAC-2D simulation to my TOMAWAC model. I was wondering if I still need to set initial and boundary conditions in TOMAWAC steering file?

- in other words, is importing water level/current files from TELEMAC-2D sufficient to describe boundary conditions for TOMAWAC? - My TELEMAC-2D is based on TPXO data input-

Cheers,

NZ

The administrator has disabled public write access.

TOMAWAC boundary conditions when having water level and current files 2 years 11 months ago #39381

tfouquet OFFLINE Moderator Posts: 294 Thank you received: 112	Hello Importing water level and currents is setting your water level and your current, not your wave height and period ... so yes you still have to set your boundary counditions. regards T.
	The administrator has disabled public write access.

TOMAWAC boundary conditions when having water level and current files 2 years 11 months ago #39519

NZrigat OFFLINE Senior Boarder Posts: 65 Thank you received: 16	Hi, Thanks for you response, I realised how naive my question was. For reference, I set boundary conditions using the keyword TYPE OF BOUNDARY DIRECTIONAL SPECTRUM, then set source terms of wind generation and energy dissipation.(After having wind data imported as binary) Cheers, Nayef
	The administrator has disabled public write access.