open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi dear, can you help us

I have this error when I use telemac

Program received signal SIGSEGV: Segmentation fault - invalid memory reference.

Backtrace for this error:
... The following command failed for the reason above

Hello,

It seems to be a problem with your mesh, did you try to see how your mesh was ?
You can also use a debbug version of telemac it might tell you more about the reason it fails.

Hope it helps

The mesh

I think there is a confusion with the boundary file...
Mesh03_BC.bc2 is probably the BK file for saving the boundary conditions but this is not the file required for Telemac which is probably a ".cli" file...

Regards

I change but the error is still now

I wouldn't say you have to change the extension. Telemac doesn't take care of the file extension...
This file is clearly not a boundary condition file for telemac.
You have to generate the right cli file with BK...
Regards

I do it with BK but I have the same problem

Please, read the BK manual and save the right layer to the right format.
I think you're not on the right object.
BK should offer you to save le right layer as a "Conlim Table File (*.cli)" and not as a "Conlim Boundary Conditions Generator (*.bc2)"

I have it

Probably a problem with your model but hard to say without the files...
By the way, you should first update you version as there is no "help" for old versions and in your case, v7p0 is a really old version...
Before trying to run the simulation in parallel, you could also try in sequential...

Regards