open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi everyone,

I am currently using Telemac v8p4 and attempting to couple Telemac3D with Tomawac using different meshes. To create a suitable input file, I followed these steps:

Conversion from Serafin to Med geometry + boundary using the converter.py srf2med command.

Afterward, I utilized tel2tom to generate the mesh with correct weights as outlined in the notebook's manual guide. However, during this step, I encountered errors like the following (I attching the error in the photo):

Can anyone who has encountered the same problem kindly provide me with some advice?

Thank you!

Anh

Hi
Maybe you could test with the serafin file to identify if this is a problem with med files of with tel2tom...
Regards

Hello,
Christophe is right, i know the example in the notebook is done with med, but you don't have to use med to use tel2tom, it should work with serafin too.

Regards

Thank you so much you both, based on your advices I used directly serafin file which is created by Blue Kenue to tel2tom and it worked already. Thank you again for your help.

Best regards,