open TELEMAC-MASCARET The mathematically superior suite of solvers

hello,
i have run a model over the north sea area the problem is that if i run the model over single processor, i get an error of memory access violation at the first iteration.
while if i run the model over 8 processors , i get insufficient virtual memory problem error after some number of iterations.

i try to compile telemac system with 1,5 gb for stack but the error appear again.
attached the cas and fortran file
hope to find soultion soon

thanks
mtayel

Hello,

could you also send me your geometry and boundary conditions files, so that I try to run your case on my computer?

Regards,

Elodie (This email address is being protected from spambots. You need JavaScript enabled to view it.)

hello,
thanks for your concern, i hope to find a solution soon
attached the geometery and boundary files, but the wind file will be so big to upload "i used it before with telemac2d and windx,windy is the first,second variables".

please also take care of the problem of global output file in the following post
thanks
mtayel

hello,
here is the boundary

thanks
mtayel

hello,
it may be a problem with uploading the boundary file

thanks
mtayel

hello,
excuse me because of the upload

thanks
mtayel