open TELEMAC-MASCARET The mathematically superior suite of solvers

Dear all,

I have used and install Telemac many times. Currently, I try to install it in my new computer. I use the automatic installation and of course, it met an error. and then I follow the instruction of the forum

wiki.opentelemac.org/doku.php?id=instruc...tomatic_installation

And it shows that I need Username and password. So I use the 'ot-svn-public' as use name and 'telemac1' as password.

It shows that No more credentials or we tried too many times.

is anybody also met the same problems and how to solve it?

Thanks so much

The password is telemac1* not telemac1.

That might be the issue.

I have change the password into telemac1*

and it start into download the source files. However, after a while, it is shows that Checked out revision 10847.


I try several times, it is the same problems. Anybody know how should I figure it out.

Best regards

This means it worked and that it download it all.
You just have to follow the rest of the guide.

Hi all,

I followed all the instructions montionned in this link,
wiki.opentelemac.org/doku.php?id=instruc...tomatic_installation

But I did't know how to lunch telemac!

thank you.

Hi

Read the user manual and try to use the various example downloaded during the installation process.

Regards

Hi
Did't found this Manual.

Have a look into the documentation directory!

How to run is explained here:
wiki.opentelemac.org/doku.php?id=installation_on_windows

under how to run a simulation.

That should at least tell you if your telemac is properly installed.

Hope it helps