open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi, i have install the version 7p3 of Telemac Mascaret. Here are what it show after a first test. Is it correct, or what did i have to do to finish the installation and use it normally.

Thank you

Hello,

You have to make sure that the systel file ("systel_v7p3" in your case) is found into the configs folder (path: C:\opentelemac-mascaret\v7p3\configs).

I'll try to make more emphasis on how to make a first run with telemac2d in order to avoid such issues.

I hope this helps.

Best Regards,
José Andrés.

Thank you for your response, but i didn't find anywhere in opentelemac-mascaret folder on disk C:/ the file "systel_v7p3", but i saw anothers systel files in the config folder. What is wrong?

For compiling the program successfully you had to use a systel file where you specified the configuration you wanted to use (scalar, ect.) and that systel file should be put back into the folder configs (as I told you before, the path of this folder is C:\opentelemac-mascaret\v7p3\configs). The error you are getting is because that systel file you use is not into the folder above mentioned. How to solve your problem? Put the systel file you used for the compilation into the folder 'configs'.

I hope this helps.

P.S.:If you can't solve it, feel free to contact me by e-mail: This email address is being protected from spambots. You need JavaScript enabled to view it..

Best Regards,
José Andrés.