TELEMAC-MASCARET Forum: water depth too high due to initial conditios. (1/1)

Welcome, Guest

TOPIC: water depth too high due to initial conditios.

water depth too high due to initial conditios. 3 months 3 weeks ago #45266

giuliaperego
OFFLINE
Fresh Boarder
Posts: 22
Thank you received: 1

Hi!
I am simulating a river in telemac-3d. I have a boundary condition of prescribed discharge upstream at the top of the domain, and a prescribed elevation downstream at the estuary, where I give the tide values (varying between about -1 m and 1 m).

The downstream part of the river has a negative elevation (bottom.png picture), some points reach -10 m above sea level.

The problem is that, due to the negative elevation of the bathimetry, during the simulation, the prescribed elevation at the boundary downstream causes a water depth of several meters in the channel (water depth.png) which is not realistic!
How can I fix this problem?
Thanks a lot
Giulia

Attachments:

Bottom.png (688KB)
boundaries.png (706KB)
waterdepth.png (795KB)

The administrator has disabled public write access.

water depth too high due to initial conditios. 3 months 3 weeks ago #45267

c.coulet OFFLINE Moderator Posts: 3722 Thank you received: 1031	Hi Are you sure you didn't make a confusion between Water depth and free surface? if the bottom level is -10m and the prescribed elevation is between -1m and 1m, the water depth should be between 9m and 11m...
	Christophe The administrator has disabled public write access.