open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi,

I'm having trouble using Fudaa to set boundary conditions for a mesh. I had done so previously without any trouble, but after revising my mesh, changing the scale (from ~1m to ~10 km), and updating the .slf geometry file in my case file, the Editor 2D function still shows my old mesh without updating to the new version. I tried renaming the geometry file and changing files entirely, but Editor 2D still showed the old mesh.

Has anyone come across this before, or do you know why this might be the case? I'm not sure if Fudaa doesn't recognize meshes that are too large in scale, or if there is some other reason. Thanks!

Best regards,
Alex

Hi
This is a little bit strange but maybe this is linked to the fzip file generated by fudaa.
To sort out this problem, i'll advise you to create a new project just from the geometry file in order to generate the new boundary condition file.
Then when you have the both file (geo and boundary), you could change those file in the previous steering file and open it again with fudaa.
It should work

Regards

Thanks for your help! That sounds like a promising approach, I'll try it out.

Best,
Alex