open TELEMAC-MASCARET The mathematically superior suite of solvers

Hello
I try to use qsform , it seems that in the subroutine I have to use QS_C and QS_S but in the bedload_formula subroutine juste after the call of qsform QSC and QSS are use as for the other formula subroutine and as the qsform of the V5P3 version.

Does somebody have an exemple of qsform new version ?

May i use it with a wave file call in the streering file ?

May I modifie bedload_formula without recompilling all and if not how to recompilling on windows ??

A lot of question in the same comment , sorry
Philippe

Hello Philippe,

You may have a specific FORTRAN FILE if you have installed and compiled yourself your version (see the installation guide for this). Then you just have to add the routine bedload_formula in your fortran file, without recompiling everything.

To understand what is what in the QS you may have a look at nomvar_sisyphe (names of the variables in the output file) and point_sisyphe subroutines (at the end, these variables are added in a block called VARSOR).

The rest of the answers on next Tuesday...

Best regards,

Jean-Michel Hervouet

Hello Jean-Michel

I know what is what in QS but in qsform there is QS_C and QS_S and in the other subroutine and especially in bedload_formula who call qsform the name is QSC and QSS without the _ ??
And where I could find the installation guide ?
Best regards
Philippe

Hello Philippe,

In the download section, under Telemac, you have a folder called sources, where you have... the sources and the installation guide.

In bedload_formula, qsform is called without argument, so all what you use in qsform must be in declarations_sisyphe, whereas in bedload_formula, you have arguments with local names like QSS and QSC. So you need to use the original names in qsform.

Regards,

Jean-Michel