open TELEMAC-MASCARET The mathematically superior suite of solvers

Hi All,

I have successfully imported tidal water level and currents files from a previous TELEMAC-2D simulation to my TOMAWAC model. I was wondering if I still need to set initial and boundary conditions in TOMAWAC steering file?

- in other words, is importing water level/current files from TELEMAC-2D sufficient to describe boundary conditions for TOMAWAC? - My TELEMAC-2D is based on TPXO data input-


Cheers,

NZ

Hello

Importing water level and currents is setting your water level and your current, not your wave height and period ... so yes you still have to set your boundary counditions.

regards

T.

Hi,

Thanks for you response, I realised how naive my question was. For reference, I set boundary conditions using the keyword TYPE OF BOUNDARY DIRECTIONAL SPECTRUM, then set source terms of wind generation and energy dissipation.(After having wind data imported as binary)


Cheers,

Nayef